FREE SHIPPING TODAY

HYPERX CARE & SAFETY

Operating your device

  • Align and attach battery into base of unit - ensure it is securely locked in place.
  • Power device on by moving the power switch on the bottom of the battery to the ON position. Power device off by moving the power switch to the OFF position. Increase speed with speed+. Decrease speed with speed-.
  • With the power switch in On position, press the power button once to turn device on to level one.
  • With unit OFF, fully insert head attachment by pressing in. Remove by pulling it out.
  • Massage desired body part at the desired speed applying pressure as needed.
  • To remove the battery, make sure device is switched OFF on the bottom. Lightly press the battery release button with thumb. Firmly pull downwards on the battery handle with the other hand.

Charging your device

  • Fully charge battery for up to six hours before first use either attached or detached from the device.
  • To charge, connect the DC end of the supplied 24V adapter to the battery's charging port and plug AC side cable into wall outlet.
  • LED band on battery lights pulsate to indicate active charging.
  • Full charge is indicated when all LED lights stop flashing and remain fully illuminated.
  • Battery may be recharged at any time and at any battery level.
  • It is not recommended to fully deplete the battery to the red LED level.
  • The average run-time is 2+ hours depending on speed level and pressure applied during use.

Clean, Care & Travel

  • Use a slightly damp towel to clean device and dry with a soft cloth.
  • For storage or travel, remove battery and store in supplied carton box or HyperX Case.

Warranty

If within one year from the date you purchased one of our products, and this product fails due to a defect in material or workmanship, Hyper Pulse Inc. will replace your product, or any necessary components, free of charge.

THIS WARRANTY EXCLUDES:
a.   Damage caused by accident, abuse, mishandling, or transport;
b.   Units taken out of Australia;
c.   Units subjected to unauthorised repair;
d.   Units not used in accordance with HyperX care instructions;
e.   Damage exceeding the cost of the product;
f.   Deterioration of the delivered product resulting from abnormal storage and/or safeguarding conditions on the client’s premises, and
g.   Failure to provide the dated proof of purchase.
h.   Products purchased from an unauthorised retailer.

 

Safety Instructions

  • Use only on a dry surface of the body over clothing by lightly pressing and moving across the body for approximately 60 seconds per region.
  • Use the HyperX only on the body's soft tissue as desired without producing pain or discomfort.
  • Do not use on the head or any hard or bony area of the body.
  • Use only the applicators that provide the best-desired effect.
  • Bruising can occur regardless of control setting or pressure applied. Check treated areas frequently and immediately stop at first sign of pain or discomfort.
  • Keep fingers, hair, or any other body part away from the shaft and backside of the applicator as pinching may occur.
  • Do not place any objects into the ventilation holes of the HyperX.
  • Do not immerse in water or allow water to enter the ventilation holes of the HyperX.
  • Do not drop or misuse the HyperX.
  • Only recharge with supplied 24VDC HyperX Charger
  • Do not tamper or alter HyperX in any way.
  • Never leave the HyperX operating or charging unattended.